The NX420 model got a more aggressive design but fewer fans.
Antec is just pouring out the new houses, because after last week’s NX320, the NX420-at also, which is similar in size to the previous model but has fewer fans and built-in ARGB lights.
The front of the 416 x 221 x 463 millimeter, empty 5 kg tower house is completely covered with a grid, but a handful of ARGB LEDs have only been packed between the slats. Behind the lights, the designers left three 120-millimeter fans or a 360-mm-long radiator, while a 120-mm-long area was left free for this purpose twice and once at the rear, the latter already filled with a 120-mm-diameter air agitator at the factory.
The glass-tempered interior on the left can house Mini-ITX, microATX, and ATX-sized motherboards that can accommodate expansion cards up to 7,330 mm long, with a processor chiller height of up to 175 and a power supply length that encloses two 3.5-inch drives. without exception 185 mm. The computer also has an additional 2.5-inch storage device located on the top of the power supply cover and on either side of the system board tray.
The motherboard terminals are located on the top of the engine compartment, where in addition to the two USB 2.0, the only USB 3.0, and the two 3.5 mm jacks, you will find a reset and power button and a switch to control the RGB lights.
Simultaneously with the introduction of the Antec NX420, it was launched immediately, with a purchase price of roughly 65 euros.
Source: Hírek és cikkek – PROHARDVER! by prohardver.hu.
*The article has been translated based on the content of Hírek és cikkek – PROHARDVER! by prohardver.hu. If there is any problem regarding the content, copyright, please leave a report below the article. We will try to process as quickly as possible to protect the rights of the author. Thank you very much!
*We just want readers to access information more quickly and easily with other multilingual content, instead of information only available in a certain language.
*We always respect the copyright of the content of the author and always include the original link of the source article.If the author disagrees, just leave the report below the article, the article will be edited or deleted at the request of the author. Thanks very much! Best regards!